The dust collector is an
important home tool. Importance of it is increasing rapidly in modern society.
Without garbage cleaner, a model hose cannot be imagined. Because of that in
most of the home, the use of this tool is seen. Our floor always becomes dirty as well as our costly stylish rug, so to release dirty we should use a dust collector.
Problems are more because of
the use of more buying tool from the market. So if we can maintain it properly
then no worry but we can’t do that because we are not a mechanic. When it is
damage we fall into a serious problem. In another hand, if we learn to make
this needed machine, then we must be free from maintaining problems.
For releasing from all
hazards, we can learn how to make a dust collector. If it is an easy process,
everybody can try to make this essential dust collector. No more talk, now we
should go to the main task. Let’s go to a simple DIY.
Essential Component
There is no need a huge
ingredient to make this machine. Some few components can complete the project.
There is mentioned below:
1.
A plastic bucket
with lid (any size but not too little)
2.
A silicon
adhesive gun
3.
45 degrees curved
one-piece PVC pipe
4.
One piece
straight PVC pipe (5 Inch)
5.
A ¾ metal cutting
hole saw kit with drill machine
6.
Screwdriver
7.
Flexible pipe 4-5
feet
8.
A piece of thick
mesh
9.
A Vacuum Machine
Step One
Step Two
Again make a hole on the top
of bucket lid in the same way and same size. Insert the straight pipe into the
newly made hole. Bind the mesh on the inside orifice of pipe (the inner side of
the bucket). Following the same way block all perforation with silicon adhesive.
If there is an opening, your project will not work properly so be careful of
blocking all little holes.
Step Three
You have a flexible pipe,
right? OK, one side of the flexible pipe insert in the curved pipe which you
installed one side of the bucket. You can clasp the joint with any type of tape
that will firmly hold the joint. Now set the vacuum with the top pipe, which
installed on the lid. Clasp the opening of vacuum pipe with bucket pipe. Also
here, you should be careful of clasping the joint.
Now run your vacuum and test
your project. I hope it is working.
Final Words
If you have a vacuum machine
then nothing to worry it is a very simple task. Collect the mentioned equipment
and start the project because it is the project of dust collector there is next
to nothing cost. So if you feel, you need it then don’t be late. Just start
your step because you know well how to make a dust collector.
Comments
Post a Comment